Recovering Data with RAID Recovery
RAID or Redundant Array of Inexpensive Disks is a giant leap in the sphere of data storage and data recovery. RAID technology was developed because of the rising costs of high capacity drives in the servers for storing data. Added to it was the fact that the amount of data that needed to be stored was also increasing. In today’s world, where everything is computerized and the servers are getting overloaded, buying more and more high capacity drives is out of the question. The solution to this problem is the incorporation of raid hardware.
As the acronym RAID suggests, raid recovery uses an array of low cost drives to replace singular high capacity drives, mostly for redundancy and protection. This is because a collection of these inexpensive drives has greater capacity than a single costly drive or large capacity storage device and also can recover easily from system hazards like a circuit problem. In cases of a system failure in the server environment, raid recovery can easily be performed without shutting down the system. The success of the data recovery depends on the version of RAID that is used. Over the years, different versions have come on such as RAID 0, RAID 1, RAID 5, and RAID 10.
Repairing Your RAID
When people cannot access their files or folders in their computer, they start to panic. People always think that their data is gone for good. The truth is, in most cases data and documents are safely stored within your hard disks. If you have a RAID (Redundant Array of Inexpensive Disks), your inability to access data might occur due to some of the drives being corrupt. RAID recovery can be done to repair your hard disk drives and restore previous data.
When you send your hard disks for raid recovery, the technician will firstly categorize your issue into one of the two categories – hardware based issue or software based issue. Next, the computer expert will test which of the drives are the ones that are causing problems. In addition, based on their assessment, they can then carry out the appropriate actions to repair your RAID. Even if your whole RAID becomes corrupt or inaccessible, do not fear as RAID recovery will be able to help you regain access to yur documents and data inside your hard drive. So if you think you are facing any RAID issues, drop by your local computer store or consult the help of specialists on the Internet.